Deer Leap Clay Stamp A
Deer Leap Clay Stamp A - Image 2
Deer Leap Clay Stamp A - Image 3

Deer Leap Clay Stamp A

฿70

SKU LHQCSXM1174000 Category

Our Deer Leap Clay Stamp A leaves a leaping dear shape imprinted in your clay, ideal for adding detail to your polymer clay jewelry.

  • Cutting Edge is 0.4mm, leaving clean cuts that require minimal sanding.
  • Sizes listed are in mm and are measured from the inside edges of the cutters and represent the finished size of your clay pieces.
  • Clay Cutters with Inner line imprints are 1.5mm-2mm below cutting edge.
  • All our clay cutters are designed with a sturdy thick base for extra strength and comfort.
  • Clay cutter color may vary depending on material availability. (Usually Beige)
  • Our clay cutters are a 3D Printed product made from PLA, a bioplastic made by from plants such as corn, cassava and sugarcane.
  1. Make sure your conditioned clay is rolled firmly on to your work surface. 
  2. Lightly dip the cutting edge of your clay cutter into corn starch.
  3. Press the clay cutter firmly on to your clay then gently pull it back up.
  4. For best results repeat from step 2 for additional cuts.

*Corn starch is used to stop clay sticking to the sides of your clay cutter, water can also be used for this. 

  • Wipe clean with soapy water.
  • Don’t place cutters near the oven or store in direct sunlight. Excessive heat may cause warping.

Related products